
Net-2000™ VCU Users Manual
Version 4.0, December, 2013
VO
IP Mode
*N
ote: Dial, ring, and busy tones are standard North American call progress tones.
Figure 24 DTMF Key Pad
4.10.4.1 Send Button
The Send button sends the digits entered in the DTMF digit window out to the select device (encoder or decoder)
4.10.4.2 Clear Button
The Clear button allows the operator to delete all the digits entered in the DTMF digit window.
4.10.4.3 BK SP Button
The BK SP button allows the operator to delete the last digit entry from the DTMF digit window.
Encoder Radio Button
When the Send button is selected and the Encoder radio button is active then the digits in the DTMF window are
sent from the encoder across the channel. A the other side of the channel the information is decoded. The encoder
and decoder radio button can not be active at the same time. The encoder passes the DTMF data in-band (within the
regular voice data bits) so that normal DTMF tones pass seamlessly from the encoder to the decoder. The decoder
synthesizes a DTMF tone in response to reception of an in-band DTMF tone data in the frame.
4.10.4.4 Decoder Radio Button
When the send button is selected and the Decoder radio button is active then the Net-2000™-VCU sends tone
directly to the local decoder to output the digits as entered in the DTMF digit window. The decoder and encoder
radio button can not be active at the same time.
Close
Selecting the Close button closes the DTMF pop-up window.
4.11 Channel Settings
The Net-2000 can be configures to encode / decode speech from one of three communications channel sources. The
default channel is Ethernet loopback. Only one communication mode may be selected at a time. After switching
from one communication mode to another it is necessary to select the start button in order to initiate the change.
(Subject to Change) Page 27
DVSI CONFIDENTIAL PROPRIETARY
Kommentare zu diesen Handbüchern